Technical News
-
Common Diamond Segment Problems and Effective Solutions During Production
Learn about common quality issues in diamond segment manufacturing, including size deviation, density problems, hardness variation, and low strength, with practical solutions from production experienceREAD MORE -
How to Determine the Linear Speed of Diamond Wire Saws
Diamond wire saws are cutting tools used in conjunction with diamond wire saw machines; the linear speed of the wire is closely linked to cutting efficiencyREAD MORE -
Why are different diamond wire saws used for marble and granite?
During the sawing process, the springs facilitate the rapid discharge of stone slurry Consequently, spring-type diamond wires are the preferred choice for cutting marbleREAD MORE -
Guidelines for the Break-in Period of Bridge Cutting Machines
Bridge cutting machines are specialized equipment; operators must receive training and guidance provided by the manufacturerREAD MORE -
How to Properly Use a Diamond Wire Saw?
Do not initiate cutting from a sharp, pointed edge or corner If possible, round off or grind down the corners; if this is difficult to do mechanically, you may manually use the diamond wire itself to round off the edgeREAD MORE -
Process Requirements for Diamond Wire Saw Machines
Master the precise tension control, linear speed calibration, and motor load management required to run a diamond wire saw machine efficiently without snapping the wire loopREAD MORE -
Factors Causing Diamond Saw Blades to Fail to Cut or Lose Segments
The primary cause of segment fracture is that the hardness of the segment s metal bonding agent is significantly higher than that of the workpiece materialREAD MORE -
Important Considerations for Stone Cutting Machine Operators
Before starting the equipment, carefully inspect the oil supply system If any faults are detected, immediately report them to the relevant management personnel so that maintenance staff can carry out repairsREAD MORE -
Issues Preventing Diamond Saw Blades from Operating at High Quality
Improper Basic Tension: The diamond saw blade tension requires recalibration Loose Screws on the Feed Screw Bearing Block (Carriage): Adjust the rotating feed screw mechanismREAD MORE -
What Are the Preliminary Preparations for Stone Quarrying?
There are numerous methods for quarrying stone Traditional methods include blasting, flame cutting, and the line-drilling and splitting technique M...READ MORE
