News
-
Important Notice on WANLONG’s Official Bank Accounts
To ensure payment security, please use only the authorized accounts listed below In order to meet the demand ofREAD MORE -
Guidelines for the Break-in Period of Bridge Cutting Machines
Bridge cutting machines are specialized equipment; operators must receive training and guidance provided by the manufacturerREAD MORE -
How to Properly Use a Diamond Wire Saw?
Do not initiate cutting from a sharp, pointed edge or corner If possible, round off or grind down the corners; if this is difficult to do mechanically, you may manually use the diamond wire itself to round off the edgeREAD MORE -
Process Requirements for Diamond Wire Saw Machines
Master the precise tension control, linear speed calibration, and motor load management required to run a diamond wire saw machine efficiently without snapping the wire loopREAD MORE -
Factors Causing Diamond Saw Blades to Fail to Cut or Lose Segments
The primary cause of segment fracture is that the hardness of the segment s metal bonding agent is significantly higher than that of the workpiece materialREAD MORE -
Important Considerations for Stone Cutting Machine Operators
Before starting the equipment, carefully inspect the oil supply system If any faults are detected, immediately report them to the relevant management personnel so that maintenance staff can carry out repairsREAD MORE -
Issues Preventing Diamond Saw Blades from Operating at High Quality
Improper Basic Tension: The diamond saw blade tension requires recalibration Loose Screws on the Feed Screw Bearing Block (Carriage): Adjust the rotating feed screw mechanismREAD MORE -
What Are the Preliminary Preparations for Stone Quarrying?
There are numerous methods for quarrying stone Traditional methods include blasting, flame cutting, and the line-drilling and splitting technique M...READ MORE -
Causes of Cracking During Grinding Operations
The workpiece possesses surface residual stresses that exceed its fracture limit; specifically, prior machining, grinding, or heat treatment processes have left behind residual mechanical and thermal stresses within the surface layerREAD MORE -
Maintenance Measures for Diamond Wire Saw Cutting Machines
Mining-grade wire saw cutting machines typically require continuous operation for periods exceeding 12 hours; such prolonged operation inevitably leads to a certain degree of wear and tearREAD MORE
