News
-
Quartz countertop processing precautions
Quartz is generally installed by splicing When choosing the splicing position, try to avoid corners and furnace mouthsREAD MORE -
Precautions for fully automatic stone edge grinding machine
1 Ensure that the instrument is used at a suitable temperature and in a clean environment, while avoiding direct sunlight and keeping it dry and ventilatedREAD MORE -
Mining cutting machine maintenance tips
Before using the mining cutting machine, all components must be inspected first After the installation is completed, start the trial operation to ...READ MORE -
Why opening holes is the top priority in quartz stone processing
The opening of the quartz stone countertop should be smooth and not jagged, let alone a simple right angle, to prevent small cracks or chips when opening the holeREAD MORE -
Precautions for sewage treatment in stone processing plants
All in all, there are many options for wastewater treatment methods in stone processing plants, and the appropriate method can be selected according to the pollution characteristics and treatment requirements of the wastewaterREAD MORE -
Stone factory sewage treatment method
Stone factories can use chemical methods such as oxidation, reduction, and precipitation to treat organic and inorganic substances in sewageREAD MORE -
Do you remember these three points about circular saw maintenance
Check the screws, guide rails, bearings, etc regularly every month and add grease; replace the grease every six months to keep the screws, guide rails, bearings and other moving parts well lubricated and reduce the mechanical wear rateREAD MORE -
What are the main parts of the infrared bridge stone cutting machine
The main structure of the infrared bridge stone cutting machine includes a machine base, beam, transverse moving device, longitudinal moving device, feeding device, segment assembly, workbench and electrical control systemREAD MORE -
What else could wear down a diamond segment but itself
The teeth of the diamond segments are not sharp enough If the saw teeth are too sharp, the cutting load will increase and wear will inevitably occurREAD MORE -
What force is used when cutting a diamond segment
Therefore, when sawing and grinding rocks, the hardness of the bond should be higher; when sawing soft rock, the hardness of the bond should be lower; when sawing and grinding large and hard rocks, the hardness of the bond should be moderateREAD MORE
