As a stone edge cutting machine favored by stone dealers on the market, it plays a very important role in stone equipment. If we do not maintain the equipment properly while using it, it can cause the equipment to malfunction. The most common is abnormal noise. So how to judge the fault through abnormal noise?
 
What is the reason for the abnormal noise of the stone edge cutting machine?
 
1. When the stone edge cutting machines a sharp sound, it means that the diamond segment is blunt and needs to be cut;
 
At this time, you should stop working immediately and cut off the power supply, otherwise the segment will be damaged;
 
If water cutting or the amount of lubricant is small, additives should be added;
 
The segment welding is asymmetrical and causes friction with the base material, requiring the segment to be adjusted or replaced;

 
2. There is obvious wear and tear sound, giving people a heavy feeling. The reason is that the hardness of the saw blade and stone does not meet the requirements, and the saw blade needs to be replaced;
 
3. The load of the stone edge cutting machine increases. If there is no machine failure, it is usually a failure of the diamond segment or matrix, as machine failure can also increase the load. Therefore, pay attention to distinguishing faults when troubleshooting.