The saw blade is an essential accessory in the stone cutting machine and plays a vital role in production. So what are the reasons for saw blade problems during the production process?
 
1. Wear at the connection between the base body and the segments
 
Reason: The material being cut is very wear-resistant, and cutting debris is mixed into the cutting slit and cannot be discharged.
 
Solution: Use protective teeth at special positions on the base body, and use larger-pressure cooling water flow to enhance the chip removal effect.
 
2. Segmented damage
 
Cause: Segment adhesive is too hard; Saw blade feed speed is too fast.
 
Solution: Choose a saw blade with a softer bond according to the material being cut; reduce the feed speed of the saw blade.
 
3. Uneven wear on both sides of the diamond segment
 
Reason: The saw blade cuts at an angle; the water volume on both sides is different, and the water volume on one side is insufficient.
 
Solution: Check the inclination of the saw blade; check the cooling water system.
 
4. Saw blade deflection
 
Reasons: The chips of the material being cut are mixed into the cutting seam, causing uneven stress on the base body; the flange diameter is too small or the flange diameters on both sides are inconsistent; there is foreign matter between the saw blade and the flange; it is not installed correctly.
 
Solution: Clean up debris and enhance chip removal effect; Adjust or replace the flange; Install correctly according to the instructions.