When we are ready to use the rock cutting machine, one thing we need to do is to debug it. After all, only after debugging the mechanical equipment can the staff know the specific operation methods and shortcomings of the mechanical equipment. So how do we debug the rock cutting machine?
 
1. Check carefully according to the electrical wiring diagram and ensure that it is correct before starting
 
2. Check the firmness of each motor and the tightness of belt and chain by manual rotation, and adjust it to a good state
 
3. Check the operation of each transmission mechanism to ensure that the operation and movement are flexible, there is no obvious jamming, and the connection is stable
 
4. Check the correctness and security of the part position
 
5. Check the correctness and firmness of each protection (dust prevention) device
 
6. Check the operation of the operating handle and button to ensure the sensitivity and effectiveness. After the above inspection, all lubricating parts shall be lubricated and the injected oil shall be kept clean. At this time, partial commissioning can be carried out item by item