For example, we chose a diamond with a high diamond density, but its sawing performance is not very good. Diamond does not become brittle, so it is difficult to create new sharp edges.
2. The saw wire is broken. Usually the wrong application parameters are used or the wire quality is too poor, which means that the bond between the plastic/rubber and the diamond beads is not strong, causing debris to enter the diamond wire, and soon there is localized contact between the magma or chips and the wire rope, Rubbing, the wire rope connecting wire starts to break, which may also be caused by improper use of adhesive.
The breakage of the wire rope may also be caused by improper selection of the wire rope and beaded steel body, poor heat treatment after injection molding, etc.
Wire saw installation precautions
Before installing the wire saw, confirm the direction of the wire saw. It must be ensured that the direction of the arrow on the wire saw is consistent with the sawing direction. Some used ropes cannot see the direction of the arrow on the eraser. Direction determines the direction of the wire saw.
Pass the jigsaw through the drilled hole in the surface to be cut. Note: When cutting vertical surfaces, the running direction of the wire saw must be the direction of entering from the horizontal hole and passing through the vertical hole. When cutting the horizontal plane, determine the cutting direction according to the actual situation. The wire saw should always run in the same direction from new to old. If used upside down, it may render the entire jigsaw useless.
